Threeway Steel Co., Ltd
E-mail: sales@srtsteelpipe.com
Address: 22nd Floor, Royal Wing Tower, Long Champ International Building, No.9 Xiangfu Road, Changsha, Hunan, China, PC: 410116Phone:0086-731-8873-9521
Keywords :Piling Pipe,SSAW steel pipe,welded pipe,LSAW steel pipe Update : 2017-05-02 View(s) : 2744
Piling pipe can most conveniently be extended with a splicer. This is designed with a taper for a drive fit without welding so no advance preparation is required or a slip on splice requiring welding. If water is a problem, roofing mastic swabbed around the joint probably will be adequate. ...
Keywords :API 5L steel pipe,welded pipe,ssaw steel pipe,seamless steel pipe Update : 2017-05-02 View(s) : 1701
There are essentially 3 distinct kinds of pipe, and they differ in the way they had been produced. There is seamless steel pipe that begins out as a strong circular and following getting heated nearly too melting stage, a hole is pierced via the middle with a device and produces the pipe. This ...
Keywords :Piling Pipe,SSAW steel pipe,welded pipe,sawh steel pipe Update : 2017-04-28 View(s) : 1616
Piling pipe are designed to transfer structural loads through the foundation to soils below. They range in diameter from less than 6 inches to over 8 feet which gives piling pipe the ability to fit a variety of project needs. If additional length is desired, they can be easil...
Keywords :API 5L steel pipe,welded pipe,ssaw steel pipe,seamless steel pipe Update : 2017-04-28 View(s) : 1828
API represents American Petroleum Institute. API 5l steel pipe means that the pipe must be made according to the standards of this institute. API steel pipe is a kind of line pipe conforming to American oil standard. Line pipe is the process which can transfer the oil, steam, water from the gr...
Keywords :API 5L steel pipe,welded pipe,ssaw steel pipe,erw steel pipe Update : 2017-04-27 View(s) : 1755
The raw material is the most important, because the quality control which usually begins with the purchase of raw material is during the all steps of production process. We should choose the best and most proper and efficient raw material, for example, high-quality, continuous-cast, full...